Factory Set Condition; Trouble Shooting; Operation; Initial Power Up (Commissioning) - CGS Merlin GDP2X Manuel D'installation Et D'utilisation

Installation & Operation Manual

Factory Set Condition

FUNCTION
BMS relay ON/OFF for-
Auto Start-
FAB Auto Reset

Trouble Shooting

Detector not responding
Service message
End of Life message

Operation

Initial Power Up (Commissioning)

On connecting mains power, the GDP2X panel will 'warm up' for approximately 60 seconds –
during this time the screen will display an 'initialisation' message while system searches for
detectors wired to the system.
We recommend all gas detection systems be commissioned by a competent/trained engineer to ensure
correct installation and operation!

Main Screen

When the system has finished initialising – the main screen will appear.
The main screen gives an overview of the status of each zone monitored by gas detectors and if
the gas line/supply is on (open) or off (shut).

Zone Status

Zone Status
ZONE... OK
ZONE... ATTENTION
ZONE... DANGER
ZONE... DISABLED
ZONE... -- X --
IOM Iss: 2 03-22
OPTION Explanation
- Gas -Gas changes relay state with gas valve status only.
- OFF In the event of a power loss, the system will require resetting manually.
- OFF Manually reset system following fire panel alarm.
Fault. Possible Cause/Correction.
Incorrect wiring or screening of cables.
ID switches not properly configured.
Termination switches not set up correctly.
Detector requires service – contact supplier.
Detector requires replacement – contact supplier.
System Condition
Gas levels are safe.
No error conditions.
Detector(s) are in pre-alarm status or
Detector(s) require service or
Detector gas sensor(s) end of life.
Dangerous gas levels have been detected or
Detector gas sensor fault has been detected or
Detector has lost its signal with the control panel.
See section: Alarm Messages.
No detector signals received from the zone.
Detector not installed or Detector not configured correctly.
Merlin GDP2X
9