ST
Installation on jacketed fiber Installation sur fibre avec gaine de protection
7
Make sure all the slack fiber is pushed back inside the jacket. First mark the buffer at the end of the jacket.
Then mark it again at 11 mm.
Si la fibre glisse légèrement à l'intérieur de la gaine de protection poussez-la le plus possible à l'intérieur de la gaine.
Marquez d'abord le revêtement à l'extrémité de la gaine de protection. Marquez-le ensuite à 11 mm.
Standard Release 01.00 October 2007
11 mm
Catégorie courante Version 01.00 Octobre 2007
ST
Page 26