Rointe BRF1100RADC Manuel D'installation Et D'utilisation page 34

An installation kit is included in the product packaging. You will need a drill, a rubber mallet,
a spirit level and a pencil to complete the installation.
WARNING: The weight of some of the products may be heavy. The installation
may require two people.
IMPORTANT: Please follow these instructions carefully.
34
0.6 m
ZONA EXTERIOR
2.25 m
1. Remove the packaging and check that the installation
contains brackets, screws, rawl plugs and a cardboard
template.
2. Select a suitable location on the wall. Place the
template on the wall and mark the holes for the
brackets and screws. Observe the minimum distance
requirements from the previous page.
Use the floor as a base for the template, not the
skirting board.
3. Remove the template and carefully drill out the
marked holes.
4. Secure the upper brackets with the rawl plugs
and screws provided. Then fix the lower bracket. To
distinguish it, the lower bracket has a different design
from the top ones.
0.6 m
ZONA EXTERIOR
0.6 m
Bottom bracket
Top bracket