Call Button - Cobra microTALK FRS 237 Guide D'utilisation

Using Your Radio
Operation
To Select a Privacy Code:
Mode Button
1. After selecting a channel, press the
button until the small numbers next to the
channel number flash on the LCD.
2. Press the
Privacy Code
to select a privacy code. You can hold the
or Down button for fast advance.
3. When your desired privacy code is displayed:
a. Press the
Channel Button
setting and proceed to other functions.
b. Press the
setting and return to
c. Do not press any buttons for 15 seconds
to enter the new setting and return to
Standby Mode.
Listening for a Response
Listening
When You are Finished Talking:
1. Release the Talk
transmissions. Your microTALK
always in
Call buttons
Volume
Volume Button
To Adjust the Volume:
1. Press the Volume Up
A double beep sound is used to indicate
the minimum and maximum volume levels
Volume Level
(L1 through L7).
English
8
Mode
Channel Up or Channel Down button
Mode button to enter the new
Lock button to enter the new
Standby Mode.
button to receive incoming
® radio is
Standby Mode while the Talk or
are not pressed.
or Volume Down button.
Introduction

Call Button

Up
Mode Button
•
Scanning Channels
Channel Button
•
Operation Customer Assistance Warranty
Call Button
To Alert Another Person That You Are Calling:
1. Press and release the Call button.
The other person will hear a two (2) second call
tone. You cannot send or receive transmissions
during the two (2) second call tone.
See page 11 on how to select
between ten (10) call tone settings.
Scan
Your microTALK ® radio can automatically scan
main channels (1 through 14) or the privacy codes
(00 through 38) within one (1) main channel.
To Scan Main Channels:
1. Press the Mode button until the Scan icon and
the main channel number flashes on the display.
2. Press the Channel Up or Channel
to begin scanning the main channels.
The radio ignores privacy codes
while scanning main channels.
3. The Scan icon will continue to be displayed
when Scan is On. Your radio will continue to
scan all main channels and stop if an incoming
transmission is detected.Your radio will remain
on that channel for ten (10) seconds. During this
time, you can:
a. Press and hold the Talk button and
communicate with others. Your radio
will remain on that channel and return
to Standby Mode.
b. Press the Channel Up or Channel
button to resume scanning channels.
c. Press the Mode button to
privacy code scanning (see page 10 for
further details).
Nothing comes close to a
•
•
Down button
Down
proceed to
Cobra ™ 9