Operations; Selecting An Input Source - Pioneer PDA-5001 Mode D'emploi

Operations

Selecting an input source

This section explains the basic operation of this unit when
connected to the monitor. Outlined on this page is how to
turn the monitor's main power on and off, put this unit in
the operation or standby mode and how to select
connected components.
Before you begin, make sure you have:
÷ Made connections from the monitor and video box to AV
components and/or a personal computer.
÷ Set up the on-screen menu to input signals from
components connected to INPUT1 through INPUT4 as
described in the section "Setting Up the System" on
page 14.
If no connections are made to these terminals,
on-screen setup is not necessary.
STANDBY/ON
2,5
INPUT
3
2,5
MENU
ADJUST
3
SET
SIZE
DISPLAY
Operation panel of the
plasma display monitor,
PDP-502MXE
1
Switch MAIN POWER on the monitor to the on
position to turn the main power on.
The STANDBY/ON indicator lights red.
2
Press STANDBY/ON to put the monitor in the
operation mode.
The STANDBY/ON indicator turns green.
STANDBY
/ON SCREEN MUTING
SIZE
INPUT
VOL
VIDEO Y/C
1 2
4
RGB RGB
(BNC) (D-sub)
3 4
DISPLAY
MENU
SET
Remote control unit
supplied with PDP-502MXE
3
Press INPUT on the remote control unit or the
main unit to select the input.
On the main unit, input changes each time INPUT is
pressed as follows.
3 INPUT1
INPUT4 2
÷ Input cannot be changed when a menu screen is
displayed.
÷ When the SCART terminal is selected as the input
for INPUT1 and/or INPUT2 in the system settings
described on page 14, the auto function feature is
capable of automatic input switching when the
connected component is operated.
÷ When a signal from a personal computer is input, if
the signal is not compatible with the monitor, "OUT
OF RANGE" will appear on the screen.
4
Use VOLUME +/– on the remote control unit to
adjust the volume.
If no audio connections are made to this unit, this step
is not necessary.
5
When viewing is finished, press
to put the unit in standby mode.
The STANDBY/ON indicator will blink and then remain
lit (red) indicating that the standby mode is engaged.
Operation is not possible while the STANDBY/ON
indicator is blinking (red).
6
Switch MAIN POWER on the monitor to the off
position to turn the main power off.
CAUTION
Please do not leave the same picture displayed on the screen for
a long time. Doing so may cause a phenomenon known as
"screen burn" which leaves a ghost, or residual, image of the
picture on the screen.
3 INPUT2
INPUT3 2
STANDBY/ON
17
<ARE1351> En