Adjustment - AWS Scale BLADE-100 Manuel De L'utilisateur

BLADE Scale
VIII.

Adjustment

1. Press and hold the MODE key until the display
shows "CAL".
2. Press the MODE key again. The display will flash
"CAL" followed by the calibration weight value (see
chart).
3. Place the calibration weight on the center of the
weighing platform. Make sure you are using the
correct weight for your specific model.
4. Once the weight is accepted, the display will show
"PASS" then return to normal operation.
IX. Troubleshooting
• Problem: Scale will not turn on
Solution: Check the batteries
•
Problem: Displayed weight fluctuates randomly
•
• Solution: Make sure your workspace is stable and
free of any air currents or vibration
• Problem: Displayed weight is inaccurate
Solution: Perform a calibration adjustment
•
X. Error Codes
1. OUTZ - Zero range has shifted. Perform calibration
adjustment. If the problem persists, the load cell may
be permanently damaged due to overloading.
2. O-Ld - Maximum capacity exceeded. Remove the
extra weight to avoid damaging the load cell.
3. L - Batteries are low. Replace the batteries.
- English