Safety Warnings - Uline KIHLBERG JK35T-590 Manuel

TO EMPTY THE MAGAZINE
1. Pull the pusher all the way back until it snaps in
around the parking button. (See Figure 3)
2. Take the staples out and release the pusher by
pressing the parking button. (See Figure 4)
NOTE: Read these warnings to prevent injuries
to yourself and those around you.
• Never use oxygen, combustible gases, CO
or high pressure gas tanks as power sources. The
stapler may explode and cause serious injury.
• Use only dry, clean pressure-regulated compressed
air to drive the stapler.
• Eye protection must be worn by the operator and
others in the work area.
• Always use personal protection equipment as
required, such as ear protection, hard hats, etc.
PAGE 2 OF 9
OPERATION CONTINUED
REMOVING STUCK STAPLES
1.
Figure 3
Figure 4

SAFETY WARNINGS

• Never use a defective stapler. Ensure the trigger
, steam
2
• Do not modify the stapler.
• Always disconnect the stapler from the air supply
• Never leave a loaded stapler unattended.
• Always assume that the stapler is loaded. No
Park the staple pusher in its rear position. Just loosen
the 2 screws (a) holding the front plate and move
the plate downward to remove. Remove any staple
remnants. Remount the parts in the reverse order
and release the pusher. (See Figures 5 and 6)
a
operates properly and all screws and nuts are
secured tightly at all times.
and empty the magazine when taking a break
or ending work, when servicing the stapler or
eliminating malfunctions.
horseplay! Respect the stapler as a working
implement.
Figure 5
Figure 6
a
0421 IH-3533