Gerlach GL 7734 Mode D'emploi page 5

device.
15. Remember that some parts of the device and housing become very hot during
operation, so be extremely careful not to touch them, you may get burned.
16. NEVER cover the appliance while it is in operation or when it is not completely cold
17. Remember that the appliance's heating elements take time to cool down completely.
18. When using the device, ensure adequate space above and around the device, during
operation, the device must not touch any easily flammable objects such as decorations,
paper towels, curtains, clothing, etc.
22. Keep a distance of at least 1 m from other objects.
23. The device cannot be used with external timer switches or other separate remote
control systems
24. Do not expose the device to direct weather conditions such as rain.
25. Periodically check the condition of the power cord. If the power cord is damaged, it
should be replaced by a specialist repair shop in order to avoid a hazard
26. Do not use the device near flammable materials
27. Do not use this heater in the immediate vicinity of a swimming pool
29. Do not use if there are visible signs of damage to the heater
30. The heater must not be placed directly under an electrical socket.
31. Use the heater on a level and stable surface or attach it to the wall if the manufacturer
has provided for it.
It is recommended that, for increased safety, the electrical installation should be equipped
with an automatic residual current device with a starting current of 30mA.
Note: If the power cord or plug is damaged, it must be replaced or repaired by a
specialized repair shop.
II. WARNINGS
1. Never use the device if it is damaged or not functioning properly.
2. Never use the device if it has previously been dropped and shows visible signs of
damage.
3. Do not use extension cords or other electrical outlets that do not comply with applicable
electrical standards and regulations.
4. Any repair, disassembly or replacement of any parts should always be performed by a
specialized facility.
5. In the event that the device and components such as electrical contacts, plug or cable
get wet, dry the device and its components before use.
6. Do not use the device with wet hands.
7. If you are concerned that the device has been damaged, NEVER repair the device
yourself.
8. Never wash the device under running water or in such a way that water drips down to it.
9. Make sure the device has cooled down before storing.
10. Do not touch the housing during use. Only the knobs and switches should be used
during work. After switching off, wait for the device to cool down.
5