ION TOTAL PA GLOW 2 Guide D'utilisation Rapide page 9

Troubleshooting
If the sound is distorted: Try lowering the volume control of your sound source, musical instrument,
or microphone. Also, try to reduce the overall volume of Total PA Glow 2 using the Master Volume
knob.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower the bass
level. This will allow you to play the music louder before clipping (distortion) occurs.
If there is a high-pitched whistling noise when using a microphone: This is probably feedback.
Point the microphone away from the speaker.
If you can't hear the microphone over the music volume: Turn down the music volume from your
source.
When I press Previous (
presses of the button will jump to presets. Hold the button down to seek to the next station. (If
applicable)
If the radio station channel is flashing: The unit is currently muted. Unmute to stop the flashing and
resume playback.
If the Bluetooth logo is flashing rapidly: The unit is currently in pairing mode.
If the Bluetooth logo is flashing slowly: A device is paired, but the music is muted. Unmute to stop
the flashing and resume playback.
The USB track number (Example: 001) is flashing slowly: The USB drive music playback is muted.
Unmute to stop the flashing and resume playback.
The LCD shows "NONE": If a USB drive or SD card is already properly inserted, make sure it
contains playable files (MP3s, 16-bit WAVs, FLAC, APE, and WMA files).
If you cannot connect your audio device to Total PA Glow 2 via Bluetooth:
•
Have your audio device (e.g., smartphone or tablet) and Total PA Glow 2 as close together as
possible while trying to connect. Make sure both the audio device and Total PA Glow 2 are
unobstructed by walls, furniture, etc.
•
Reset the Bluetooth connection on Total PA Glow 2 to disconnect Total PA Glow 2 from any
other audio device and restart the search process. If this does not work right away, power off
Total PA Glow 2 and then power it back on. See
more information.
•
Reset the Bluetooth connection on your audio device by turning Bluetooth off and back on.
You can find this under the Bluetooth menu in the Settings for your phone or other audio
device.
If this does not work, and you have connected to Total PA Glow 2 before, find Total PA Glow 2 in the
list of available or previously connected devices in your audio device's Bluetooth menu, tap the
"gear" or "i" icon located next to it and then select Unpair or Forget. Turn Total PA Glow 2 off and
back on and try pairing again once it reappears in your available devices list.
Note: If Total PA Glow 2 has been paired to another audio device recently that is still within range,
you may need to repeat this process with that audio device to fully disconnect.
) or Next ( ), it doesn't increment to the next FM station: Short
Operation > Pairing a Bluetooth Device for
9