Parts List - ITC SPT189 Manuel De L'utilisateur

OPERATION
Install the trimmer guide on the tool base with the clamp screw (A). Loosen the
clamp screw (B) and adjust the distance between the bit and the trimmer guide
by turning the adjusting screw (1 mm or approx. 3/64
distance, tighten the clamp screw (B) to secure the trimmer guide in place.
Clamp Screw (A)
Adjusting Screw (B)
When cutting, move the tool with the guide roller riding the side of the work piece.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and unplugged before attempting to
perform inspection or maintenance.
Replacing Carbon Brushes
Remove and check the carbon brushes regularly. Replace when they wear down to
the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both
carbon brushes should be replaced at the same time.
Use a screwdriver to remove the brush holder caps. Take out the worn carbon
brushes, insert the new ones and secure the brush holder caps.

PARTS LIST

Please refer to Schematic Drawing on page 15.
N PART NAME
O.
1 Label
2 Bolt Screw
3 Self Screw
4 Plank
 Cover
 Power Supply
 Power Cord
8 Motor Housing
9 Brush Covers
10 Brushes
11 Field Assembly
12 Bearing
13 Insulated Pad
14 Bolt Screw
 
per turn.) At the desired
th
Trimmer Guide
N
O.
1
1
1
18
19
20
21
22
23
24
2
2
2
28
PART NAME
Armature Assembly
Fan
Bearing
Rubber Washer
Housing
Rubber Pin
Switch Seat
Switch
Capacitor
Knob
Spring Sleeve
Sleeve Screw
Washer
Tool Base
!