ITC SPT189 Manuel De L'utilisateur page 4

SPECIFICATIONS
Superior Laminate Trimmer
 Motor: 120v, 60Hz, 400W
 Collet chuck capacity 1/4"
 No-load speed (RPM) 26,000/min.
 Overall length 204 mm (8")
 Net weight 1.2 kg (2.6 lbs)
Includes:
 Straight guide assembly
 Trimmer guide assembly
 Trimmer base assembly (For chamfering with straight bit)
 Trimmer shoe
 1/4" Collet cone
 10 mm Wrench
 17 mm Wrench
Designed to accept:
 1/4" router bits
 Straight & groove forming bits
 Edge forming bits
 Laminate trimming bits
INSTALLING or REMOVING BITS
CAUTION: Always be sure that the tool is switched off and unplugged before
installing or removing the bit.
Insert the bit all the way into the collet cone and tighten the collet nut securely with
the two wrenches (supplied). To remove the bit, follow the instructions procedure in
a reverse order.
CAUTION: Don't tighten the collet nut without inserting a bit, or the collet cone will
break. Only use the wrenches provided with the tool.
Adjusting Bit Protrusion
To adjust the bit protrusion, loosen the nut and move the tool base up or down as
desired by turning the adjusting screws. After adjusting, tighten the nut firmly to
secure the tool base.
Switch Action
To start the tool, move the switch lever to the "ON" position. To stop, move the switch
lever to the "OFF" position.
OPERATION
Set the tool base on the work piece to be cut without the bit making any contact.
Then turn the tool on and wait until the bit reaches full speed. Move the tool forward
over the workpiece surface, keeping the tool base flush and advancing smoothly
until the cutting is complete.
When doing edge cutting, the work piece surface should be on the left side of the bit
in the feed direction.
CAUTION:
Moving the tool forward too fast may cause a poor quality cut, or damage to the bit
or motor. Moving the tool forward too slowly may burn and mar the cut. The proper
feed rate will depend on the bit size, the kind of work piece and the depth of the
cut. Before beginning the cut on the actual workpiece, it is advisable to make a
sample cut on a scrap piece of lumber. This will show exactly how the cut will look
as well as enable you to check dimensions.
4 4
!
!
!