urmet domus 1092/303 Manuel Utilisateur page 9

5. Connect the video source to the VIDEO BALUN by means of a coaxial cable.
Important note:
It is advisable to use a "A" – "B" 75 Ω coaxial cable for each video signal whose total length between
the source side and the user side is less than 50 m.
A
6. Make the necessary connections on source side.
7. Power the device by means of the power connector "7".
8. Check that the red LED "1" is on.
9. Check that the video signal is present: the green LED "5" should light up.
10. Equalise and adjust the video signal:
a adjust the dip switches "2" (see table 3) to obtain the required definition and contrast levels;
b turn the potentiometer to reach the required brightness level.
11. Repeat the operations in step 10 and firstly change the dip switch settings if the picture is not right.
Important note:
Consider the physical connection to be made with the utmost attention.
Although the video balun system allows to carry video signals on UTP cables generally used in IT systems,
the balun system will not be electrically compatible with the signals present online in any way. For
this reason, the utmost care is required when installing a video balun system using wires already installed
in an IT network.
Dip switch settings and distances for connection between Ref.1092/300 and Ref.1092/303
DIP SWITCH
SETTINGS
* For distances close to or higher than 1200 metres, use of an Urmet Domus Ref.1092/302 active
transmitter (instead of Ref.1092/300 passive transmitter) is recommended.
DS1092-018A
All manuals and user guides at all-guides.com
24 AWG UTP CAT5 CABLE OR HIGHER
A + B ≤ 50 m
(PASSIVE - ACTIVE)
DISTANCE (m)
250 ÷ 350
350 ÷ 450
450 ÷ 550
550 ÷ 630
630 ÷ 690
690 ÷ 750
750 ÷ 810
810 ÷ 870
Table 3: distances with 24 AWG UTP CAT5 cable
DIP SWITCH
DISTANCE (m)
SETTINGS
B
870 ÷ 950
950 ÷ 1050
1050 ÷ 1150
1150 ÷ 1235
1235 ÷ 1315 *
1315 ÷ 1385 *
1385 ÷ 1460 *
1460 ÷ 1530 *
9