Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USE
The 1092/303 device may only be used as a receiver (RX).
The device allows to connect a video source using one pair of twisted wires in a dedicated UTP CAT5
cable.
It may be used in combination with the following transmitters:
Ref.1092/300 → "1ch passive transmitter/receiver"
Ref.1092/302 → "1ch active transmitter"
Important note:
•
The use of Urmet Domus Ref.1092/800-801 power supplies with 13.2 V output is recommended.
INSTALLATION
1
2
3
PART
1
2
3
4
5
6
7
1.
Make sure that no units are powered before starting the installation procedure.
2.
Strip the UTP CAT5 cable being careful not to cut the wires.
3.
Cut the wire whose colour corresponds to that of the video source to be connected. Choose one of
the free wires.
Important note:
It is advisable to use the 4 wire pair (white/brown - brown) for single video signal systems on one only
UTP.
4.
Strip the chosen wires by approximately 5 mm and insert them in the device making sure that the
polarity is correct because the UTP video signal is polarised (see table 2).
UTP WIRE COLOURS/POLARITY
PAIR
1
2
3
4
8
All manuals and user guides at all-guides.com
4
Video signal equalisation dip switch (definition and contrast).
Video signal level adjustment potentiometer (brightness).
UTP video input terminal board
Video signal output BNC connector
COLOUR
White-green
Green
White-orange
Orange
White-blue
Blue
White-brown
Brown
Table 2
5
6
DESCRIPTION
Power LED
Video signal presence LED
Power connector
Table 1
POLARITY
+
-
+
-
+
-
+
-
7
Pair 1
Pair 2
Pair 3
Pair 4
DS1092-018A
Publicité
Table des Matières
