Publicité
Les langues disponibles
Les langues disponibles
HOW TO CLEAN KETTLE
1. Please unplug the power plug and let the pot become
cool before cleaning.
2. Please do not immerse the kettle, power cord, power
plug and power socket into water.
3. Please ensure the electronic line circuit dry.
4. Please wipe the kettle body with a damp cloth. Please do
not use scouring powder, cleaning ointment product,
they will damage the surface characteristics of kettle.
Cleaning and maintenance should not be carried
out by children unless they are at least 8 years of age and
are supervised by an adult.
HOW TO ELIMINATE SCALE
In order to keep good working condition of the kettle, it needs to remove scale frequently. If the outage happens in
advance when working, indicating that you need to clear the scale of the kettle. Please use several methods in the
following to clear the scale:
1. Please use dedicated product that can remove the scale very well, proceed in accordance with product
instructions.
2. Please add the 0.5 liter eight-degree white vinegar to the pot, need cost one hour to keep soak, then drain
white vinegar, at last wash it 4-5 times with clean water.
3. Please add 0.5 liter of water to the pot and then boil it, then add 25 grams of citric acid, later soak 15 minutes,
at last wash it 4-5 times with clean water.
TROUBLESHOOTING
Failure
it shuts down
1. It can be resolved by clearing the scale that is usually caused by the scale.
automatically
2. It also may be due to inadequate water in the kettle or empty kettle when using,
causing to start dry combustion protection devices, we follow these steps to re-setting:
in advance
again we add cold water to the pot, the dry burning protection device will be reseted
after about 2 minutes, then the kettle can work.
before boiling
1. Please check whether the connecting of plug and socket is ok or not.
2. If the power cord is damaged, you must use the same type of power cord replaced
The kettle can
by the staff of the maintenance department in the manufactory.
not work
3. When the kettle starts dry combustion, the dry combustion protection device will
shut the power.
1. This phenomenon usually happens when the kettle is used for the first time. To
There is a little
solve this trouble in accordance with Use Article 6.
peculiar smell
2. If this problem persists, add water to the pot to the maximum position, add two soup
inside water
spoons of saleratus to the water, and then drain the water after boiling.
Sources of failure and tuoubleshooting ways
Publicité
