Technic SB-R1 Manuel D'utilisation page 9

1 Tilt the speaker backwards, and screw the spikes into the screw holes on the front metal feet.
When using the spike shoes, place them under the spikes.
Screw the spikes firmly until
they stop.
Thick mat, etc.
Place each spike shoe so that the
side with an indented centre faces
up.
DO
2 While aligning the tips of the spikes with the indentations on the spike shoes, slowly bring the speaker back to the upright
position.
3 In the same way as Step 1, tilt the speaker forward and screw the spikes into the screw holes on the rear metal feet.
When using the spike shoes, place them under the spikes.
4 If the speakers wobble, place the spacers under the spike shoes. (
DO NOT
Speaker (front)
Spike shoes
8)
9
(9)