Olsberg 14/534 Notice D'utilisation page 24

• Only for heater 14/536:
Remove the top front panel (Fig.4):
Caution: Before removing the top front panel
of heaters with integral room ther-
mostats, first remove the cables
from the rocker switch on the operat-
ing panel.
8. Remove the top and the side left and right
screws from the top front panel (C).
9. Remove the top front panel with both top front
insulations.
• Only for heater 14/534:
Insert the channelled bricks using the guide plates
provided, first the channelled bricks SP27, then the
channelled bricks from SP26. You will find the
number and type of storage brick packs in the sec-
tion "Technical Data".
• Only for heater 14/536:
Insert the channelled bricks using the guide plates
provided:
10. Insert the channelled bricks SP27 (Fig.5).
11. Replace the top front panel with both top front
insulations.
12. Insert the channelled bricks from SP26.
You will find the number and type of storage brick
packs in the section "Technical Data".
• Insert the heating elements into the rows of slots in
the storage core.
• Place the cover bricks on to the channel bricks
over the heating elements in such a way that the
terminals of the heating elements lie sidewards on
the channels of the cover bricks. Remove the
guide plates.
24
All manuals and user guides at all-guides.com
8.
Fig.4 Remove the top front panel
Fig.5 Insert the channelled bricks SP27
Fig.6 Heating elements and cover bricks
C
8.
8.