KUKKO Y-57 Serie Mode D'emploi page 33

KUKKO Tool factory
Series Y-57
described in the instructions above.
The hose is mounted correctly if the union nut is hand-tightened
and the hose cannot be moved by pulling or shaking it.
EN
3. Connect one side of the hydraulic hose to the connection on
the nut splitter. Insert the hydraulic hose connection into the
opening of the connection on the nut splitter. Screw the threaded
sleeve tightly onto the connection on the hydraulic cylinder with
the threaded sleeve.
If you feel that you need to use pliers, a wrench or another tool
for this process, disassemble the hose. Then repeat the process, as
described in the instructions above.
The hose is mounted correctly if the union nut is hand-tightened
and the hose cannot be moved by pulling or shaking it.
4. Check that the connections between the hose and the cylinder
and between the hose and pump are tight. Move the connected
part slightly. They must be tightly connected.
5. The hydraulic system is now ready for use.
www.KUKKO.com
33