Installation Instructions - Idylis IF50CM23NW Mode D'emploi

INSTALLATION INSTRUCTIONS

1. Remove all packaging material. This includes the foam base and all adhesive tape
holding the freezer accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials before
powering on the freezer.
WARNING
Flammable refrigerant used. Handle with care when moving freezer to avoid
either damaging the refrigerant tubing or increasing the risk of a leak.
ADJUSTING YOUR FREEZER
• Your freezer is designed for freestanding installation only. It should not be recessed
or built-in.
•
• When moving the freezer, never tilt it more than a 45· angle. This could damage the
compressor and the sealed system.
• If the freezer is tilted, let it stand in an upright position for at least 24 hours prior to
plugging. This is to allow the refrigerant to settle.
PROPER AIR CIRCULATION
•
should install it in a location where there is proper air circulation, plumbing and
electrical connections.
• The following are recommended clearances around the freezer:
Sides . . . . . 2 in.(5.08cm)
Back. . . . . . 2 in.(5.08cm)
ELECTRICAL REQUIREMENT
• Make sure there is a suitable power outlet (115 volts, 15 amps outlet) with proper
grounding to power the freezer.
•
to accommodate a two plug outlet. This is a dangerous practice since it provides no
INSTALL LIMITATIONS
• Do not install your freezer in any location not properly insulated or heated, e.g.
garage, etc. Your freezer was not designed to operate in temperature settings less
than 0 or more than 110° Fahrenheit.
• Select a suitable location for the freezer on a hard, even surface away from direct
sunlight or heat sources, e.g. radiators, baseboard heaters, cooking appliances, etc.
• Do not install the freezer in a location exposed to rain water or direct sunlight.
49-60783
Risk of Fire or Explosion due to puncture of refrigerant tubing.
7