Hiti TE 60-AVR Mode D'emploi page 16

5.1.5 Removing the accessory tool
CAUTION
Risk of injury! The accessory tool gets hot during use.
▶ Wear protective gloves when changing the accessory tool.
▶ Do not place the hot accessory tool on readily flammable materials.
▶ Pull the chuck back as far as it will go and remove the accessory tool.
5.2 Types of work
CAUTION
Risk of injury! Loss of control over the combihammer.
▶ Check that the side handle is fitted correctly and tightened securely.
Check that the clamping band is engaged in the groove provided on
the tool.
Observe the safety instructions and warnings in this documentation and on
the product.
5.2.1 Drilling with hammering action (hammer drilling)
1. Set the function selector switch to this symbol:
2. Set the desired power level.
3. Press the drill bit against the work surface.
4. Press the control switch.
◁ The product starts.
5.2.2 Drilling without hammering
Note
Drilling without hammering action is possible when accessory tools with
a special connection end are used. Accessory tools of this kind are
available from Hilti. Alternatively, when the keyless quick-release chuck
is fitted, smooth-shank drill bits for wood or steel, for example, can be
used to drill without hammering.
▶ Set the function selector switch to this symbol:
5.2.3 Mixing
Note
Use the mixing paddle only with the quick-release chuck.
Use the mixing paddle only when the reduced power (50 %) setting is
active.
1. Insert the quick-release chuck in the power tool's chuck.
10 English
Printed: 28.06.2017 | Doc-Nr: PUB / 5277965 / 000 / 01
7
.
.
8