Customer Service - Novis ProBlender Mode D'emploi

Troubleshooting
In case of a malfunction, disconnect the blender completely from the power outlet. The program / speed
controller should be set to the position « » and the power switch (at the back) «
off.
Blender is overheated
• The NOVIS ProBlender is equipped with an overload protection.
In case of overload or overheating of the device, this character « » appears on the display.
In this case, the device will not operate as long as the warm light is still activated.
• For devices without LCD display, the overload is indicated by the rapid flashing of all program, speed
and button LEDs.
Blender does not start
• Is the NOVIS ProBlender properly connected to the power outlet?
• Check the correct position of the lid and positioning of the container on the drive unit.
• Check the position of the damping/centering pad.
If you cannot resolve the problem, contact your sales provider or contact the address indicated in the
Customer Service section.
Repairs of NOVIS ProBlenders may only be carried out by official
service centres. Improper repairs might cause a danger for the user.
No liability can be accepted for any damage and consequential
damage. In this case, the warranty becomes void.
Disposal
In accordance with the requirements of the European Directive 2002/96 / EC on Waste Electrical and
» should be set to Electronic Equipment (WEEE), this appliance has a mark provided with it. Please protect the environment
and the health of others by disposing of the NOVIS ProBlender properly. Discard unusable appliances by
pulling out the power plug and severing the power cable.

Customer Service

All repairs and services must be should be handled locally by an authorized NOVIS customer centre.
Please contact your sales outlet or read more on the Internet: novissa.com
The manual can also be downloaded on novissa.com.
Manufacturer and Importer
Novissa Switzerland AG
Schulstrasse 1a
2572 Sutz, Switzerland
T: +41 32 475 1015
E-Mail: info@novissa.com
This symbol indicates that the product must not be
disposed with household waste. It must be brought to a
suitable electrical / electronic equipment collection point
for proper recycling. For information on such collection
points, please contact your local authorities or point of
sale.
7