General Instructions; Installation Types - Siemens Sitraffic Sensus Unit C3077 Manuel D'installation Et De Sécurité

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH

4 General instructions

Destruction caused by over-voltage! The Sitraffic Sensus Unit is designed for a
voltage range of 8 – 32 V DC and must therefore not be used outside this voltage range.
If your on-board network can generate higher voltages (e.g. jump-starting from an external
power source or from additional stronger power generators in the vehicle), then you must
disconnect the unit from the on-board network for the duration of the over-voltage.
Damage caused by incorrect cleaning! The unit may be cleaned when required with a
damp cloth. Do not use any volatile solvents, e.g. alcohol and do not use abrasive cleaning
agents.
Damage caused by incorrect handling! The Sitraffic Sensus Unit is an electronic
device and therefore you should avoid excessive impact forces. Do not operate the unit with
pointed or sharp objects.
5 Verifying the Sitraffic Sensus Unit package contents
The Sitraffic Sensus Unit package contains:
1. One Sitraffic Sensus Unit including rechargeable battery
2. One power supply cable for cigarette lighter installation, with LED power supply indication
on the connector
3. One plastic bag including holder and one cleaning cloth
4. Three suction cups
5. One installation and safety instruction leaflet (this one)
Please check if the package content is complete and undamaged. If you find something
missing or damaged, please claim at after-sales service of your operating company
immediately!

6 Installation types

There are two possible types of installation:
Temporary installation – In this case the Sitraffic Sensus Unit is powered from the cigarette
lighter socket.
Permanent installation – In this case the Sitraffic Sensus Unit is connected to the vehicle
electrical system by an optional available power supply cable with intermediate connector.
This installation instruction describes both installation types which can be used alternatively
depending on the available accessories. The permanent installation will be described in
chapter 12.
7 Installation in vehicles transporting dangerous goods (ADR vehicles)
Danger of explosion! Installation in ADR vehicle is a case for fixed installation and must
only be performed by authorised staff! If you wish to install the device into an ADR vehicle
please contact after-sales service of
your operating company
for support.

Publicité

Table des Matières
loading

Table des Matières