Bestway 65001 Mode D'emploi page 4

NEVER USE THE AIR PRESSURE MACHINE TO INFLATE
• Inflate the air chambers with a HAND air pump. An inflation scale is provided with the product. Inflate the product until
the printed scale is charged up to the same level as that of the supplied scale. (refer the table and illustrations below)
Caution: Under and over-inflation of the boat will result in safety hazards. It is better to check the pressure of the
boat each time before use. If you use another pressure gauge, the boat pressure should not be more than the data
given on the builder's plate.
• Never stand on or rest objects on the boat during inflation.
• Inflate the bottom chamber and other accessories such as seat until it is stiff to the touch but NOT hard.
• Extended exposure to sun can shorten the lifespan of your boat. We suggest not leaving boats in direct sunlight for
more than 1 hour after use.
Item Product Inflated Size
65051 2.43 m x 1.02 m (8' x 40")
65001 3.48 m x 1.41 m (11'5" x 56")
65008 3.16 m x 1.24 m (10'4" x 49")
Oars Installation (For 65051; 65001)
Note: When the oars are not in use, lock the oars into the Oar Clasps to avoid damage.
Storage
1. Remove the Oars from the oarlocks.
Note: Keep all accessories for future use.
2. Carefully clean the boat using a mild soap with clean water.
Note: Do not use acetone, acid, and/or alkaline solutions.
3. Use a cloth to gently dry all surfaces.
Note: Do not dry the product in direct sunlight. Also, never dry with equipment such as electric blowers. Doing so will
cause damage and shorten the boat's life span.
4. Deflate the hull chambers. Deflate all the hull chambers at the same time so the air-pressure drops together. This will
prevent damage from occurring to the boat inner structures. Next, deflate the floor.
5. Fold the boat from front to back to remove additional air. You can also use a pump to drain any remaining air.
Repair
1. If there is a small puncture, repair it according to the instructions on the repair patch.
2. If the hole is too big to be repaired with the provided patch, purchase a Bestway repair kit or send the boat to a
speciality shop to make the repair.
Registration (For US/Canada customers only)
If you need to register your boat, please have the boat Hull Identification Number and model name ready and then visit
www.bestwaycorp.com/support to obtain your Certificate of Origin, or you can send e-mail to
service@bestwaycorp.us for the Certificate of Origin.
PLEASE KEEP THIS MANUAL IN A SECURE PLACE, AND HAND IT OVER TO THE NEW OWNER WHEN YOU
SELL THE CRAFT.
Inflated Size Inflated Size
Deflated Size
Chamber 2 Chamber 3
10 cm
5.4 cm
10 cm 5.4 cm
11 cm
10 cm
Lisez attentivement ce manuel avant d'utiliser votre canot gonflable.
65051;65001
Bateau
Composants:
13 cm • Pièce De Réparation
• Tuyau de dégonflage
11.8 cm
11 cm
65008
Bateau
Composants:
• Pièce De Réparation
• Tuyau de dégonflage
1
Poignée
Robuste
6
Support De
Canne À Pèche
Construction du canot
65001 / 65051
1
10
65008
1
REMARQUE: Les dessins servent uniquement à illustrer le produit. Ils ne
correspondent pas nécessairement au produit réel et ne sont pas à l'échelle réelle.
ATTENTION: Pour éviter des dommages au bateau et des blessures aux passagers, ne pas dépasser SVP les
données fournies sur la plaque du fabricant.
4
2 pales
2 manches
2 bagues
Aviron
2 accouplements
• Échelle de gonflage
Corde
• Échelle de gonflage
2 3
Coussin
Sac De Rangement Échelle Imprimée
Gonflable
7 8
Collier Dame De Nage Oeillet
3
(65001)
2
(65001)
9
8
4
5
2
10
Corde
4 5
Vanne
9 10
Corde De Sauvetage
5
6
7
6
9
8