Fitting kit
- 3 rubber inserts
- 3 BHc 5×20 screws
- 3 Ø5 plastic washers
- 3 Ø6 plastic washers
Assembly
- Place the screen on the meter block of the bike by centring it the best you can.
- Track down the central hole by knowing that the axis of this one is in 10,5 cm of the meter's cover
and drill in the Ø9,5 (photo 1).
- Fix the screen thanks to one insert (the washer taking place between the screen and the insert).The
whole is blocked by the Ø5 screw and washer.
- Track down both holes aside by centring the screen. The axis of every holes is in 3,5 cm of the edge
of the meter's cover (photo 2).
- Drill and fix with the supplied kit's remaining.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
Photo 1
FITTING INSTRUCTIONS
ADAPTABLE ON ER 6 N 2006/2008
"ATTENTION"
ERMAX NOSE SCREEN
Assembly time estimated: 15 mn
Photo 2