Cd Operation; Stopping Playback; Fast Forward/Reverse; Programmed Playback - Jensen AWM968 Guide D'installation Et D'operation

AWM968

CD OPERATION

1
2
3
4
5 AWM968
6
7
8
9
10
25
26
27
30
28 31
Inserting a CD
Insert a CD label-side up into the disc slot (10) and the disc will begin to play.
Ejecting a CD
Press the eject button (19) to stop CD play and eject the CD.
Pausing Playback
Press the 2/ button (28) to suspend or resume disc play.

Stopping Playback

Press the 5/ button (31) to suspend disc play, and "PRE STOP" will appear in the display.
Press the 2/ button (28) to resume disc play from the last position. Press 5/
"STOP" appears.
PUSH/ENTER
22 23 24
PUSH/ENTER
29 32
twice and
Track Select
Press the TUNE/SEEK/TRACK >>| or |<< button (13, 14) to advance to the previous or next
11
track on the CD. The selected track number will appear on the display. Press and hold the
12
TUNE/SEEK/TRACK >>| or |<< button for more than three seconds to fast forward or fast
13 reverse through the disc. CD play starts when the play/pause button is pressed.

Fast Forward/Reverse

14
15 Press and hold TUNE/SEEK/TRACK >>| or |<< button (13, 14)
the
buttons on the remote control (17) once for FORWARD X 2. Press and hold additional times for
16
FORWARD X 4, X 8, X 20 or PLAY. Press the play/pause 2/
17
or remote control (18) to end fast forward or reverse and resume normal playback.
18
Repeat (RPT)
Press the 6/RPT button (32) during disc play to access the repeat function. Press again to
continuously repeat the selected track (REP ONE). Press a third time to repeat all tracks (REP
19
ALL). Press once more to stop repeating (REP OFF).
Random Shuffle (RDM)
20
Press the 4/RDM button (30) during disc play to play all tracks on a CD in random, shuffled
21
order (RDM ON). Press 4/RDM again to stop random play (RDM OFF).

Programmed Playback

1. Press the PROG button (8) on the remote control to access the programmed playback
screen:
2. Use the , , or cursor buttons (16) on the remote control to access the fields on
the "PROG" screen.
3. Use the number buttons on the remote control to enter a track number in each field.
4. Press the >/|| button (19) on the remote control or highlight "PLAY" on screen and then
press the ENTER button (5) to begin playback in the numbered order indicated.
To delete the list, highlight "CLEAR" and then press ENTER. Press PROG to exit the
programmed playback screen.
Remote Control Direct Track Entry
To select a track directly, use the number pad on the remote control (10). For single digit
entries, press the corresponding number. For two digit entries, press the 10+ button followed
by the last digit (i.e., for track 16, press 10+ and then 6).
7
press the >> or <<
or
button on the control panel (28)