Publicité
Les langues disponibles
Les langues disponibles
Assembly
- Dismount the original chain guard.
- Remove the two brackets which keep the rear brake hose on the right hand side of the
swinging arm.
- Position the rear fender.
- Fix it with the original screws of the chain guard, well centre the rear fender in relation to the
tyre.
- Don't forget to harden the rear shock absorber when you ride with a passenger or on poor
road surfaces or with a passenger to avoid damaging the rear fender.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data
of our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* A few tyres, faithful to ETRTO standards, may be in fact bigger and higher than dimensions engraved on the tyre (until + 10 mm). They may be not compatible with undertrays and rear huggers which we made with
original tyres and whose dimensions correspond to these ones engraved on tyre.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
FITTING INSTRUCTIONS
ADAPTABLE ON CB 600 HORNET 1998/2002
« CAUTION »
ERMAX HUGGER
Original tyre 180/55 ZR 17.
Publicité
