Toshiba Canvio AeroCast Manuel D'utilisation page 19

2 Plug the USB cable into the USB 3.0 Host port on the Canvio
AeroCast Wireless Hard Drive.
3 Plug the AC adaptor into a live electrical wall outlet.
While charging, the battery indicator light will blink slowly
(interval time is 2 seconds).
Connect to Canvio AeroCast
You can connect to the Canvio AeroCast Wireless Hard Drive directly
with the included USB cable (Direct-Attached Storage mode) or
connect wirelessly (Wireless LAN mode).
Connect via USB
To operate via USB, connect the Canvio AeroCast Wireless Hard
Drive to the computer's USB port using the included USB cable.
For Mac users:
To write files via USB, you will need to install the "NTFS driver for
Mac" to your Mac. Refer the pre-loaded manual stored on the
Canvio AeroCast Wireless Hard Drive.
USB 3.0 port
(Sample Illustration) Connect via USB
To connect the Canvio AeroCast to your computer:
1 Make sure the Canvio AeroCast Wireless Hard Drive is
powered OFF.
2 Connect the included USB 3.0 cable to the Canvio AeroCast
Wireless Hard Drive.
3 Connect the other end of the USB 3.0 cable to your
computer's USB port.
You can now begin transferring data to and from the product.
Getting Started
Connect to Canvio AeroCast
USB cable
USB port
19