Avintage AVI97AX3ZI Notice D'utilisation page 44

1. Incline the wine cooler with 45 degrees, take out right lower hinge's screws with screwdriver (Fig.1).
2. Level the wine cooler, hold the door and take out right upper hinge's screws with screwdriver, then take
out the door, put the door safety and rotate it at 180 degree (Fig.2, Fig.3 & Fig.4).
3. Remove limited block B as per the arrows in picture, then release all the screws on limited block A, and
take away limited block A. Install the limited block A at the right side with screws, then install limited
block B, then fit the door with screws (Fig.5, Fig.6 & Fig.7).
Note: this is a two person operation
4. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is between
44