Before Use - Panasonic ET-ELT30 Mode D'emploi

Before Use

Supported projectors
J
PT-EZ590, PT-EW650, PT-EW550, PT-EX620, PT-EX520
Note
Models other than the above may also be supported. Refer to the operating instructions of the
z
projector you are using.
In this document, the alphabet letters at the end of the projector part numbers are omitted.
z
Supplied Accessories
J
Make sure that the following has been provided.
Part name
Lens cap
Note
The illustrations in this manual may differ from the actual product.
z
Detaching the lens / Attaching the lens
Before replacing the projection lens
Return the projection lens to the home position before replacing or removing it.
For details on how to return the lens to the home position, refer to the operating instruc-
tions of the projector.
Attention
Make sure that the projector power supply is switched off before attaching or detaching the
z
projection lens.
After removing the projection lens, store it safely away from vibration or impacts.
z
Before attaching the projection lens, be sure to remove the lens caps (1 each for front and rear)
z
attached to the projection lens.
Do not touch the electric contact points of the projection lens with your fingers. Dust and dirt on
z
the contacts may cause contact malfunctions.
Do not touch the surface of the lens with bare hands. Finger prints and dirt on the surface of
z
the lens will be magnified by the lens and lower the quality of the projected image. Place the
supplied lens cap on the zoom lens when the projector is not in use.
The lens is made of glass. The lens could be damaged if brought into contact with or rubbed
z
against hard objects. Handle the lens carefully.
Use a clean, soft and dry cloth to wipe away dust and dirt from the lens.
z
Do not use fluffy cloths containing oil, water or dust for cleaning. The material in the lens is
easily damaged, so do not apply excessive pressure when wiping it.
4 - ENGLISH
Appearance (quantity)
The product is delivered with a lens
z
cap attached.
The shape and size of the lens caps
z
Rear
are different for each product.
Front
(1 each for front and rear)