Getting Started; On/Off Button - PAX -100 Manuel De L'utilisateur

Pulvérisateur électrostatique portatif
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Important Safety Instructions for Battery Packs and Chargers
The unit uses a 14.4 Volt internal battery pack. The battery pack is not fully charged out of the box, read the
instructions below for proper operation.
- Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally
occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the
battery may cause irritation or burns.
- Use appliances only with specifically designated battery packs. Use of any other battery packs may create a
risk of injury and fire.
- When the charger is plugged into a power source, 16 volts are present at charging terminals. Do not
probe with conductive objects.
- Do not use a unit or battery pack that is damaged or modified. Damaged or modified batteries may
exhibit unpredictable behavior resulting in fire, explosion, or risk of injury.
- Do not modify or attempt to repair the device except as indicated in the instructions for use and care.
- Do not expose a battery pack or appliance to fire or excessive temperature. Exposure to fire or
temperature above 265°F (130°C) may cause explosion.
- Follow all charging instructions and do not charge the unit when the temperature is below +40°F
(+4.5°C), or above +105°F (+40.5°C). Charging improperly or at temperatures outside of the specified
range may damage the battery and increase the risk of fire.

Getting Started

For safety reasons, the unit is not shipped fully charged. It is recommended to fully charge it before using the
unit. To do so, plug the block side of the charger into a wall socket and the other side into the machine.
- Before using the unit, the tank must be filled. Follow the instruction on page 4 to remove the tank.
- Aim towards the surface you wish to spray. Grip the handle firmly with all four fingers and press
the button with your thumb to activate the unit. When finished, let go of the button to turn off
the unit.
- It is important to keep moving when using the unit. Standing still will cause electrostatically
charged droplets to accumulate at the tip of the unit.
Grounding Bar
Handle
Charging Port &
Power Switch
(Other Side)
Battery Capacity
LED Indicators
PAX-100 User Manual
SAVE THESE INSTRUCTIONS

On/Off Button

3
Tank Lock
Tank
Manuel d'utilisateur PAX-100
Nozzle

Publicité

Table des Matières
loading

Table des Matières