Electrolux EXD16DN3W Notice D'utilisation page 19

All manuals and user guides at all-guides.com
•. Make.sure.to.direct.airflow.at.the.wet.
clothes.shown.as.picture.below.
•. For.thick.and.heavy.wet.clothes.may.
not.get.the.best.effective.dehumidifica-
tion.
C AUTION!
•. Do.not.cover.the.air.outlet.of.the.
unit.with.clothes..It.may.cause.
excessive.heat,.fire.or.failure.of.
unit.
•. Do.not.place.the.wet.clothes.on.
the.top.of.the.unit.and.do.not.
make.the.water.drop.into.the.
unit..It.may.cause.electric.shock,.
creepage.or.failure.of.unit.
4.8 How.to.Use.Timer.Function
The.TIMER.function.enables.you.to.either.
Delay.Start.or.Delay.Stop.the.unit.in.the.
choice.from.0.5.hour.to.24.hours.
When.the.unit.is.on,.first.press.the.Timer.
.button,.the.Timer.Off.indicator.light.
illuminates..It.indicates.the.Auto.Stop.pro-
gram.is.initiated..Press.it.again.the.Time.
On.indicator.light.illuminates..It.indicates.
the.Auto.Start.is.initiated.
Press.or.hold.the. .or.
the.Auto.time.by.0.5.hour.increments,.up.
to.10.hours,.then.at.1.hour.increments.up.
to.24.hours..The.control.will.count.down.
the.time.remaining.until.start.
The.selected.time.will.register.in.5.sec-
onds.and.the.system.will.automatically.
revert.back.to.display.the.previous.humid-
ity.setting.
When.the.Auto.start.&.Auto.stop.times.are.
set,.within.the.same.program.sequence,.
TIMER.ON.OFF.indicator.lights.illuminate.
identifying.both.ON.and.OFF.times.are.
now.programmed.
Turning.the.unit.ON.or.OFF.at.any.time.
or.adjusting.the.timer.setting.to.0.0.will.
cancel.the.Auto.Start/Stop.function..When.
LED.display.window.displays.the.code.of.
P2,.the.Auto.Start/Stop.function.will.also.
be.cancelled.
NOTE:
•. Before.entering.TIMER.setting,.make.
•. Before.entering.TIMER.setting,.make.
4.9 Fault.Codes
AS-.Humidity.sensor.error--Unplug.the.
unit.and.plug.it.back.in..If.error.repeats,.
call.for.service.
ES-.Temperature.sensor.error--.Unplug.
the.unit.and.plug.it.back.in..If.error.re-
peats,.call.for.service.
P1-.Unit.is.defrosting--.Allow.the.unit.time.
to.automatically.defrost..The.protection.will.
clear.after.the.unit.self.defrosts.
P2-.Bucket.is.full.or.bucket.is.not.in.right.
position--.Empty.the.bucket.and.replace.it.
in.the.right.position.
E3-.Unit.malfunction--.Unplug.the.unit.
and.plug.it.back.in..If.error.repeats,.call.for.
service.
EC-.Refrigerant.leakage.detection--.With.
this.new.technology,.the.display.area.will.
appear.EC.when.the.unit.detects.refriger-
ant.leakage,call.for.service.
.pad.to.change.
4.10 Removing.collected.water
There.are.two.ways.to.remove.collected.
water.
Use.the.bucket
When.the.unit.is.off,.if.the.bucket.is.full,.
the.unit.will.beep.8.times.and.the.Full.
indicator.light.will.flash,.the.digital.display.
shows.P2.
When.the.unit.is.on,.if.the.bucket.is.full,
the.compressor.turns.off.and.the.fan.turns.
off.after.30.seconds.for.drying.the.water.
of.the.condenser,.then.the.unit.will.beep.
8.times.and.the.Full.indicator.light.will.
flash,.the.digital.display.shows.P2.
Follow.the.step.below.to.remove.the.col-
lected.water.from.the.bucket:
sure.power.is.being.supplied.to.the.unit.
sure.pressing.HUMIDITY.or.button.sets.
one.desired.room.humidity.first.
ENGLISH
19