Product Structure And Function - Kerbl 322081 Guide D'utilisation

4. Product Structure and Function

Your trailer camera set contains the following:
Wireless Video Camera
Camera installation
The camera can be installed anywhere on the trailer using the mounting
foot with its two swivel joints. Make sure that the included cable can be
used to reach a power source.
Set channels
Push the sun shield on the camera back and screw the lens cover off. In
the bottom right third you will see two micro switches that can be opera-
ted with a sharp object.
Attention! If you change the transmission channel on the camera you must also change the reception channel on the LCD
monitor correspondingly.
Wireless 7" LCD Monitor
Menu
Switch the LCD monitor on using the on/off switch. Press 'Menu' to navi-
gate between the options (see below). Use the 'up' and 'down' buttons to
control this.
The following Menus are available:
Picture – Image Adjustment
This is where you can set brightness, contrast and colour saturation using
the up and down buttons.
Channel Option – Channel Settings
This is where you can switch the automatic camera change on or off (au-
toscan on/off) and set the time (0-30 s) for how long one camera should be shown. This is also where you can select the
mirror view option.
System
The background colour and the language are set here.
Remote Control for the 7'' LCD Monitor.
Attention! Remove the plastic protection from
the battery in the remote control before use.
mute
up
volume +
down
image mode
language
horizontal image change
All manuals and user guides at all-guides.com
on/off
menu
display source
timer
camera 1-4
vertical image change
Lens
IR diodes for
night vision
Micro switch
Remote sensor
Volume-
Suction Cup Arm for the 7'' LCD Monitor.
Clamping screw
Adjustment screws
18
Rod antenna
Menu
Volume+
On/
up
off switch
down
Select channel
Suction cup
AV out
Headphones