RocHobby Mogrich Manuel D'utilisation page 7

EN
Instructions
After setting up, follow the instructions below to operate the system.
1. Automatic code matching (the transmitter and receiver have been successfully coded before leaving the factory.)
If you need to replace another transmitter or receiver, please follow the following steps to code:
1. When the transmitter power is on and the code matching mode is on, the light keeps flashing;
2. The power supply of the receiving board is turned on, and the front lights keep flashing to enter the code
matching mode;
3. When the code matching is successful, all the transmitter lights are on and all the lights on the car are off;
Note: when code matching, please operate the transmitter to enter the code matching state first, and then
operate the receiver to enter the code matching state.
2、POWER OFF
Follow the steps below to turn off the system:
1.Disconnect the receiver power.
2.Toggle the transmitter's power switch to the off position.
Transmitter specification
Product Model
Adaptive model
RF
Transmitting power
Wireless protocol
Distance
Channel Resolution
Battery
Charging Interface
Life time
Low Voltage Warning
Antenna Type
Data interface
Temperature Range
Humidity Range
Online Update
Color
Size
Weight
Certification
Make sure to disconnect the receiver power
before turning off the transmitter. Failureto
do so may lead to damage or serious injury.
HT-TX02
Car
2.4GHz
<20dBm
ANT
>30m(ground)
256 Grade
6V DC 1.5AAA*4
NO
According to battery type
<4.45V
Built-in single antenna
NO
-10°C ~ +60°C
20-95%
NO
Black
152mm *75mm *167mm
160g
CE, FCC ID: 2AUBX-HT-TX02
5
Note