LG SXS Manuel D'utilisation page 33

Installation
Pass the refrigerator laterally through the access
Pass the
refrigerator door as shown in the right figure.
Door replacement
Mount them in the reverse sequence of removal after they pass through the access
door.
Feed water pipe installation
Before
installation
Warning
33
Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5
kgf/cm 2 ) (That is, an instant paper cup (180 cc) will be fully filled within 3 sec.).
If water pressure does not reach the rating 147 kPa (1.5 kgf/cm
necessary to purchase a separate pressure pump for normal automatic icing and
cool water feed.
Keep the total length of the feed water pipe tube within 8 m and be careful for the
tube not be bent. If the tube is 8 m or longer it may cause trouble in water feed
owing to the drain water pressure.
Install the feed water pipe tube at a place free from heat.
Connect to potable water supply only.
Refer to instructions with water filter kit for installation.
5 Max 4 3 2
FRZ 1 Min 1 2 3
TEMP TEMP REF 4 Max 5
) or below, it is
2