Télécharger Imprimer la page

Black & Decker GSTD2050 Traduction Des Instructions D'origine page 7

Publicité

Les langues disponibles

Les langues disponibles

Never drop or insert any object into any opening or
hose.
Always keep the hose and nozzle elevated above the
water tank.
Steam only in an up and down vertical motion. Never
use steamer in a horizontal position or tilt into a
backward position, this may result in hot water
discharge.
Do not place the steam nozzle directly on any surface or
the appliance power cord while it is hot or plugged in.
Use the stand provided.
Use caution when changing attachments, as they may
contain hot water from condensation. Ensure the
attachments are cooled off to avoid contact with hot
water.
The use of accessory attachments other than those
provided by BLACK+DECKER is not recommended and
may result in fire, electric shock or personal injury.
This unit is for indoor use only.
Do not cut or attempt to extend the steaming hose.
To prevent the appliance over heating, when you hang
clothes on garment hook for removing winkle, please
assemble all attached garment telescopic rod and
extend it at highest position.
Do not put perfume, vinegar, starch, descaling agents,
ironing aids or other chemicals or additives in the water
tank.
To protect against the risk of electric shock, DO NOT
IMMERSE the appliance, cord set or plug in water or
other liquids.
Care should be taken when using the appliance, due to
the emission of steam.
Unplug the appliance before filling or cleaning.
the product must be attended when in use.
Do not use without the flexible hose or steam head
fitted.
Safety of others
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning the use of the appliance by a
person responsible for their safety."
"Children should be supervised to ensure that they do
not play with the appliance."
"If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Caution! Some parts of this product can become very hot
and cause burns. Particular attention has to be given where
children and vulnerable people are present.
Children should be supervised to ensure that they do not
play with the appliance.
(Original instructions)
After use
Remove the plug from the socket before leaving the
appliance unattended and before changing, cleaning or
inspecting any parts of the appliance.
When not in use, the appliance should be stored in a dry
place. Children should not have access to stored
appliances.
Inspection and repairs
Switch off the appliance before cleaning, changing
accessories or approaching parts which move in use.
Before use, check the appliance for damaged or
defective parts. Check for breakage of parts, damage to
switches and any other conditions that may affect its
operation.
Do not use the appliance if any part is damaged or
defective.
Have any damaged or defective parts repaired or
replaced by an authorised repair agent.
Before use, check the power supply cord for signs of
damage, ageing and wear.
Do not use the appliance if the power supply cord or
mains plug is damaged or defective.
If the power supply cord or mains plug is damaged or
defective it must be repaired by an authorised repair
agent in order to avoid a hazard. Do not cut the power
supply cord and do not attempt to repair it yourself.
Never attempt to remove or replace any parts other than
those specified in this manual.
Electrical safety
This product must be earthed. Always
check that the mains voltage corresponds
to the voltage on the rating plate
Appliance plugs must match the outlet. Never modify the
plug in any way.
Do not use any adapter plugs with earthed (Class 1)
appliances. Unmodified plugs and matching outlets will
reduce the risk of electric shock.
To avoid the risk of electric shock, do not immerse the
cord, plug or motor unit in water or other liquid.
Extension cables & class 1 product
A 3 core cable must be used as your tool is earthed and
of class 1 construction.
Up to 30m (100 ft) can be used without loss of power.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
ENGLISH
7

Publicité

loading

Ce manuel est également adapté pour:

Gstm2050