Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SAFETY
This section contains information and important notes on safe start-up and handling of the
machine.
For your own safety, read these operating instructions carefully before putting the
machine into operation. This will enable you to handle the machine safely and
prevent misunderstandings as well as personal injury and damage to property. In
addition, observe the symbols and pictograms used on the machine as well as the
safety and hazard information!
15.1
Intended use of the machine
The machinery is intended exclusively for the following operations: for drilling and milling metal or
similar materials which are not hazardous to health, flammable or explosive, each within the
prescribed technical limits.
HOLZMANN MASCHINEN GmbH assumes no responsibility or warranty for other
activities and any resulting property damage or injuries!
15.1.1
Technical restrictions
The machine is intended for use under the following ambient conditions:
Rel. Humidity:
Temperature (Operation)
Temperature (Storage, Transport)
15.1.2
Prohibited Applications / Hazardous misapplications
-
Operating the machine without adequate physical and mental aptitude.
-
Operating the machine without knowledge of the operating instructions.
-
Changes in the design of the machine.
-
Operating the machine outdoors.
-
Operating the machine in a potentially explosive environment (machine can generate
ignition sparks during operation).
-
Operating the machine outside the technical limits specified in this manual.
-
Remove the safety markings attached to the machine.
-
Modify, circumvent or disable the safety devices of the machine.
The improper use or disregard of the versions and instructions described in this manual will result
in the voiding of all warranty and compensation claims against Holzmann Maschinen GmbH.
15.2
User Requirements
The machine is designed for operation by one person. The physical and mental aptitude as well as
knowledge and understanding of the operating instructions are prerequisites for operating the
machine. Persons who, because of their physical, sensory or mental abilities or their inexperience
or ignorance, are unable to operate the machinery safely must not use it without supervision or
instruction from a responsible person.
Basic knowledge of metalworking especially the correlation of material, tool, feed and speeds.
Please note that local laws and regulations may determine the minimum age of the operator and
restrict the use of this machine!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
NOTE
max. 70 %
+5° C to +40° C
-20° C to +50° C
SAFETY
28
BF16V
Publicité
Table des Matières
