EAS ELECTRIC EMRH908TX Guide D'utilisation page 24

 Remove the grease filter and carefully remove the 2 screws from the front
plate (a cross headed screwdriver will be needed to remove the screws).
 Disconnect the terminal of LED light.
 Press LED light on the back of the front plate, take the LED light out.
 Replace the lamp (commercially available LED lamp (max.1.5w).
Square/ Diameter:
33.2mm x 120mm
 Press LED light on the front of front plate, install the LED light on the front
plate.
 Connect the terminal of LED light and light leads.
 Carefully fasten the 2 screws on the front plate, reinstall the grease filter.
DISPOSAL OF OLD ELECTRICAL APPLIANCES
DISPOSAL: Do not
dispose this product
as unsorted municipal
waste. Collection of
such waste separately
for special treatment
is necessary.
Max Power Voltage
1.5W DC 12 V
The european directive 2012/19 /UE on wasted
electrical and electronic equipments (WEEE),
requires that household electrical appliances
must not be disposed of in the normal unsorted
municipal waste stream. appliances must be
collected separately in order to optimize the
recovery and recycling of the materials they
contain, and reduce the impact on human
health and the environment.
The crossed out "wheeled bin" symbol on the
product reminds you of your obligation, that
when you disposed of the appliances, it must be
separately collected. Consumers should contact
their local authority or retailer for information
concerning the correct disposal of their old
appliance.
Picture
11
Lamp Cap ILCOS D code
——
DSS-1.5-
S-33.2/120
V.7