GET RX1 RPO Guide D'installation page 6

3.
Resume the initial position
of the
adjuster: rotate clockwise for
7 rounds.
If the engine does not start or does not work properly after this
procedure, e.g. for an incorrect installation of the ECU or an
inaccurate idle and TPS calibration:
1. Uninstall GET RX1 Pro ECU.
2. Install the OEM ECU back and resume the original engine idle setting.
3. Start the bike and verify that the engine is working properly.
4. Turn off the engine, uninstall the OEM ECU and re-install GET
RX1 Pro ECU.
5. Repeat steps 1, 2, 3 of "Idle regulation".
F. SYMBOLS AND CERTIFICATIONS
We declare that this product supplied is compliant with
RoHS Directive 2011/65/EU amended by the Directive
2015/863/EU (RoHS3) relative on the Restriction of
the Use of Certain Hazardous Substances.
G. DISPOSAL
Pursuant to art. 26 of Legislative Decree no. 49 of 14
March 2014, "Implementation of Directive 2012/19/EU
on waste electrical and electronic equipment (WEEE)".
The crossed-out wheelie bin symbol displayed on a product or its
packaging indicates that when the equipment reaches the end of its life
cycle it must be disposed of separately from other waste for purposes
of treatment and recycling. Once such products reach the end of their
life cycle, users may dispose of them free of charge at special municipal
centres for the collection of waste electrical and electronic equipment, or
return them to the distributor under one of the following arrangements:
- very small products, i.e. equipment with no external dimension
exceeding 25 cm, may be returned with no obligation to buy to
EN
throttle position
6
7
ROUND