GET RX1 RPO Guide D'installation page 3

6. To use and manage the GPA technology, it is necessary to install
GET GPA Switch or GET LC-GPA module (both sold separately), or
manage it with GET Maya Software (sold separately).
7. To change the RX1 Pro injection map, it is necessary to use
GET Maya programming software (sold separately).
8. If the bike does not start or the engine is irregular, be sure that the RX1
Pro ECU chosen is compatible with your bike model and year, verify that
the ECU is connected properly, and always perform a TPS calibration.
9. This ECU has been developed for bikes without power
restrictors. Remove them before installing GET ECU. This
manual contains some example of standard power restrictors:
please contact your bike dealer to get more details about your
bike power restrictors and where they are located.
10. OEM handlebar commands for map change and launch
control will not work after installing GET RX1 Pro ECU. To grant
proper functionality and reliability use only GET Map Switch
(included in the kit) and GET LC-GPA module (sold separately).
B. RX1 PRO SPECIFIC INSTALLATION
RX1 PRO is a fully programmable plug&play ECU. RX1 PRO is
the best solution both for original and modified engines: it is
possible to adjust the calibration map through both WiGET App,
by using the WiFi-COM device, and/or MAYA software.
WiGET App
RX1 Pro comes with 2 maps developed by GET R&D
Department, which can be easily switched thanks to the
Map Switch included in the kit.
3
EN