Step 11: Work Table - DK2 POWER OPS240 Guide De L'utilisateur

STEP 11: WORK TABLE

1. Use the 8 flat bolts and hardware provided.
2. Tighten the 2 bolts on the underside table supports that were left loose in previous
assembly steps.
3. Re-check all assembly bolts and equipment bolts, and tighten if required.
USE 8 BOLTS
PROVIDED
NOTE: Grease the rack teeth and the spline with standard grease. Keep the log beam free of
grease and keep clean when splitting. The ram slides on a teflon plate, so keep it clean from
grease and wood particles.
STEP-BY-STEP INSTRUCTIONS
ASSEMBLY
v.210823 | 21