Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

> Slowly and evenly move the hair straighteners from root to tip. Do not hold the
hair straighteners in the same place for
more than 8 to 10 seconds. This will
achieve the best results without subjecting
your hair to excess stress or damage.
> To shape the ends, turn the hair straighten-
ers inwards or outwards before pulling the
ends outwards.
Using the crimpers
> Connect the straighteners/crimping
attachment [12] to the multi-functional
styler.
> Slide the selection switch [11] to the
"crimp" position [c]. The crimpers can now
be used.
> Divide the hair into individual sections. Hold the hair section taut and place
between the crimpers at the root.
> Close the crimpers for approximately 10 seconds. This will achieve the best
results without subjecting your hair to excess stress or damage.
> Open the crimpers and take out the hair.
> Repeat the process until you reach the tip.
Notes
The multi-functional styler features a safety switch-off function. After approx. 25
min, the operation indicator lamp [4] starts to flash to remind you about the au-
tomatic switch-off. If you want to use the multi-functional styler for longer than
30 minutes, switch the device off and then immediately on again. The safety
switch-off function is then reset to activate again in 30 minutes.

6.4 After use

> Place the sliding switch [5] on the device in position 0.
> Place the multi-functional styler with the support stand [13] on a stable, hori-
zontal and non-flammable surface to cool down, or hold the multi-functional
styler in your hand.
> After each use, pull the mains plug out of the socket.
55

Publicité

Table des Matières
loading

Table des Matières