Use; Breast Pump Functioning; Accessories Preparation; Using The Breast Pump - DTF MEDICAL kitett Fisio Pro Notice D'utilisation

Note: Follow the exact order of the steps below to get the correct use of the breast pump.
a) Breast pump functioning
The FISIO® PRO breast pump should be plugged into the power supply.
• Check that the values on the breast pump (volts and Hz) corresponds to the values of your distribution
network.
• Connect the breast pump to the power supply.
NOTES:
• Check if the breast pump is suitable for the wall outlet.
b) Accessories preparation
NOTES:
• Only use the accessories provided in the kit or those manufactured by DTF MEDICAL.
• Before use, check that the KIT EXPRESSION components are free from defect, damage or sign of wear. If this
is the case, replace them.
• All the components must be completely dry before use.
Before the first use, please refer to chapter 3 for cleaning and disinfection.
➊ Wash your hands with hot and soapy water before handling the breast pump parts.
➋ Screw the KOLOR® breast shield onto the collection container.
➌ Connect the suction tube to the inlet hose of the breast shield and to the interface bottle on the unit.
Set up of the single KIT EXPRESSION:
WARNING: Correctly close the interface bottle cap when the breast pump is used on simple pumping.
c) Using the breast pump
➊ Place the breast shield correctly over your breast ensuring the milk can flow freely into
the collection container
➋ Ensure your nipple is centred inside the breast shield. The flexible part of the breast
shield must also be properly positioned on your breast to ensure complete sealing.
➌ The cycle button allows adjusting the suction cycles. The suction button graduated from
1 to 9 allows adjusting the suction from minimum to maximum. To stimulate the lactation,
set the suction button to 1 (lowest suction) and the cycle button to 120 (quick cycles).
➍ Switch on the breast pump (position "I").
It is necessary to start with this stimulation phase in order to stimulate the milk arrival and
to activate the milk ejection reflex. This phase should last about 2 minutes. According to
your own comfort level, you may adapt these settings by increasing the suction force
and/or decreasing the cycle.
❺ After the ejection reflex, select progressively a slower cycle by turning the cycle button
clockwise and increase the suction button to obtain a good expression according to your
own level of comfort. Milk expression is optimal at the level of maximum depression and
which should not be painful.
➏ Check the proper flow of milk inside the collection container.
❼ After expressing the milk, switch off the breast pump (position "O").
4.

Use

Set up of the double KIT EXPRESSION (can also be
used as single one):
18