Chauvet EZpar 56 Manuel De Référence page 4

EZpar™ 56 QRG
AC Power
Power Linking
Fuse
Replacement
Charging the
Battery
Battery Life
Indicator
Infrared Remote
Control (IRC)
This product has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
For the maximum number of EZpar™ 56 products that you can power link at
each voltage, see the sticker on the product or the User Manual.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and
replace with a fuse of the exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
The EZpar™ 56 comes with a rechargeable lithium battery for cable-free
operation. To charge the battery, simply plug in the power cord at any time
before, during, or after operation. To charge the battery before or after operation
with all the LEDs off, leave the power switch in the Off postion. The red
indicator light for the battery turns on while the battery is charging. The green
indicator light turns on when the battery is done charging.
The battery life indicator shows the remaining amount of internal battery life
when the the menu buttons are inactive.
100%
The EZpar™ 56 is fully compatible with the IRC from CHAUVET®. For
more information on the IRC or to download instructions, go to
www.chauvetlighting.com.
75% 50%
4
EN
25%