Use Precautions - air&me CLEVAIR 2 Guide D'utilisation

COMPONENTS (SEE PAGE 2)
Mist outlet
1
Top cover
2
Handle
3
Water tank
4
Water inlet
5
Cartridge filtration
6
Tank cap
7
DIGITAL DISPLAY (SEE PAGE 3)
Hygrometer
A
Thermometer
B
ON-OFF button
C
HygroSmart Function
®
D
Electronic hygrostat Function
E
Negative Ionisation Function
F
Mist power
G
Warm mist mode
H
14
Air outlet
8
Digital control panel
9
Magnetic needle
10
Power cord and plug
11
Ultrasonic plate
12
PTC heating plate
13
Essential oils compartment
14
Diffusion power
a
Empty tank indicator
b
Negative Ionisation indicator
c
Automatic mode indicator
d
Warm mist indicator
e
HygroSmart indicator
®
f
Electronic Hygrostat indicator
g

USE PRECAUTIONS

• Never connect the appliance when the tank is completely empty.
• Fill the tank with tap water or demineralised water. Do not fill the tank with softened water
with a salt softener.
• Make sure the product is placed on a dry, level surface and 10 cm away from the wall.
• Before first use or after transportation, the unit will take approximately 30 minutes to display
the actual room temperature and humidity.
• Make sure that the removable filter and the tank are correctly positioned and depressed.
• Do not remove the float from the tank, as this will prevent the unit from starting.
FILLING THE TANK (SEE PAGE 3)
Take the tank by the handle and lift it.
1
Turn the tank over, unscrew the cap.
2
Fill the tank with cold water. Do not fill it with hot water, it could create some leaks.
3
Screw back the cap clockwise.
4
Replace the tank on its base, using the float as a guide.
5
For safety reasons and to avoid overheating the unit, the humidifier will turn off automatically
when the tank is empty and the indicator
OPERATING INSTRUCTIONS
1. Fill the tank.
2. Plug the power cord in an electrical socket.
3. Turn the appliance on using the ON-OFF button (
digital display shows the humidity and temperature measured in the room thanks to the
sensor on the power cord (± 5% error margin) and the The device starts in Automatic Mode
(a light comes on: ).
d
4. Press the buttons of the touch control panel to select the different modes..
lights up.
b
). After pressing the ON-OFF button, the
C
15