Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION (continued):
DIRECT MOUNT INSTALLATION
Please refer to Table 1 for torque spec on all bolts/screws.
Note: Adjustable angle is 0-90°
1. Remove the bracket mounting screws on the fixture, open the side lid of the bracket. (Fig. 5)
2. Attach the direct mount bracket to square pole with bolts and tighten to spec, pull wire through bracket and into
the junction box, then connect the wires. (Fig. 6) If installing to a round pole, please remember to remove the
silicone plate. (Fig. 8)
3. Attach fixture to the mounting bracket, tightening bolts to spec and secure side lid. (Fig. 7)
5
7
Direct Mount
Bracket
Square Pole
EiKO Global, LLC • 23220 W. 84th St, Shawnee, KS 66227 • (P) 1-800-852-2217 • (F) 1-800-492-8975 • eiko.com
EiKO Canada • 81 King St, Barrie, Ontario L4N 6B5 • (P) 1-705-721-5189 • (F) 1-705-721-7855 • orderdesk@eiko.com
Fixture
Side Lid
Adjustable
0-90º
6
Direct Mount
Bracket
Bolt
Pole
Cable
Square
Pole
Junction
Box
Direct Mount
8
Bracket
Round Pole
Fixture
Adjusting
Screws
Side Lid
Fixture
Silicone Plate
Publicité
