smart and green Key Mode D'emploi page 6

controlling the light
switching on and oFF the light
the indicator light flashes.
=
Standby
button
color mode
buTTon buTTon
selecting a color
the indicator light flashes.
=
color
Press and hold (approx. 3 seconds) this
buTTon
button to pass through all available colous.
Press briefly the button again to resume the
selecting a color mode (ambience)
the indicator light flashes.
=
mode
buTTon
rotation of colors
sound + color
Sound effect on any selected color *
candle bleu
candle effect - lEds flicker
candle
candle effect - lEds flicker
*
SOUND + COlOr
the indicator lights up white.
=
briefly press this button (in this mode)
to select a new color.
rotation of pale
color
colors
buTTon
10
Briefly press this button to switch off or on
the light (and restore previous light mode).
= You can briefly press one of
these two buttons as well to switch
on the light (the same way as for
standby button).
Briefly press this button to
change the color.
nine-color
Press it briefly then to set the color.
color scrolling, etc ...
Briefly press this button to change the
color mode (ambience).
color indicaTes mode selecTed
ryThme
The lead color flashes once before the cycle starts.
warm
rotation of hot colors
cold
rotation of cold colors
cycle oF
8 modes
rainbow
Scrolls through all the colors
sweeT
adjUsting the light intensity
managing a groUp oF lights
ViewinG the StatuS of the liGhtS
cycle
uSinG a Group of liGhtS
cUstomising one light (From a groUp)
mode
buTTon
saVing a scene (in groUp mode)
the indicator light flashes.
=
Briefly press this button to increase or decrease
the light intensity according to the status of
the light (see cycle).
inTensiTy
buTTon
Press and hold this button to progressively
increase or decrease the light intensity to
maximum or minimum (see cycle).
note that the reduction in light intensity increases
the battery life proportionally.
the indicator light flashes.
=
Briefly press this
button to display the
status of the lights.
group
buTTon
the indicator light flashes.
=
Briefly press one of these two buttons
to select one light from the group.
previous nexT
buTTon buTTon
=
You can then individually set the color
or intensity of this light with these buttons
(see chapter controlling the light).
color inTensiTy
buTTon buTTon
=
Briefly press this button to return to
group
buTTon
the indicator light flashes.
3s
=
Press and hold (approx. 3 seconds) this button to
record a scene (that is to say the state of a group of
lights) so you are able to restore it afterwards.
this recording cancels the previous one. the lamps
scene
flash once in white.
buTTon
75%
50%
25%
Control
100%
CyCle
50% 75%
light free
BluE flash
(in free mode).
light paired with this
remote control
(in Group mode).
GrEEn flash
group control.
11