AUTO-HAK Z12 Guide Rapide page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
Washer
M10x35
ø42xø13x3
This towbar is designed to assembly in following cars:
MITSUBISHI GALANT 4/5 doors (E50), produced since 11.1992 till
08.1996 and MITSUBISHI GALANT 4 doors (EAO), produced since
09.1996 till 10.2004, catalogue number Z12 and is prepared to tow trailers
max total weight 1800 kg and max vertical load 75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
M10x35
Washer
ø42xø13x3
M10x35
1
M12x75
3
From manufacturer
1. If necessary, remove the underseal from around the fitting points of the frame
members.
2. Dismount the bumper and the protection shield.
3. Cut out fragment of the bumper as shown on the fig. 2.
Washer
ø42xø13x3
M10x35
Fig. 2 Bumper's opening
4. If necessary, open the ends of the frame members by removing the end-plates
from the rear panel. Slip main bar of the towbar (pos. 1) to the frame members in
this way, so holes in the towbar tally with holes in the frame.
2
Fix the towbar to frame members using bolts M10x35mm (pos. 6) – see fig. 1.
5.
6. Reassemble the bumper.
Fig. 1
7. Fix tow-ball (pos. 2) and socket plate (pos. 3) using bolts M12x75mm (pos. 5)
from accessories.
8. Tighten all bolts according to the torque shown in the table.
9. Connect electric wires of 7-bolts socket according to the instruction of the car.
(Recommend to make at authorized service station)
10. Complete paint layer damaged during installation.
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate note in registration book (at authorised
service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar must be always
kept clear and conserve with a grease.
The instruction of the assembly
Cut out 50x50mm
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm