e-conolight E-WKL Serie Manuel page 3

INSTALLATION INSTRUCTIONS
E-WKL Series
1500L and 5000L LED Portable Worklight
CAUTION: Changes or modifications not expressly approved could void your authority to use this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved could void your authority to use this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-005 (B)/NMB-005 (B)
CARE AND CLEANING:
CAUTION: Always make sure that the worklight is unplugged and cooled down before attempting to clean it.
• Clean the lamp head, lens, cover, and lamp stand regularly with a non-abrasive cleaner.
• Allow worklight to cool down completely before storing.
• Store in a safe place, out of the reach of children.
MAINTENANCE:
If the light does not work, check the following:
• Ensure the fixture is properly plugged into the power source.
• Ensure the switch is in the ON position.
FCC NOTICE CLASS B
CARE AND CLEANING / MAINTENANCE
www.e-conolight.com |
Document:
Created By:
888.243.9445 | FAX: 262.504.5409
Date
DCR#