Oregon OR25TBS-1 Manuel D'instruction page 18

Assembly Instructions
Step 3:
3a: Rotate tank tongue assembly on the crate base corner so that axles are clear of the base .
3b: Locate wheel assemblies, Flat washers, Castle nuts, Cotter pins and Dust caps from the hardware kit .
3c: Remove the protective cover from one axle shaft and the plastic cover from one wheel .
3d: Install the wheel (with the valve stem pointed out), outer bearing, flat washer, and castle nut .
3e: Tighten the castle nut until snug and rotate the wheel three full turns to seat the bearings .
3f: Back off (loosen) the castle nut just enough to align the hole in the axle with the notches in the castle
nut, allowing installation of the cotter pin . Do not loosen more than necessary to install cotter pin .
3g: Spin the wheel to verify it spins freely . Note: A small amount of play is acceptable .
3h: Insert cotter pin and split/bend the pin end left and right .
3i: Install the dust cap .
3j: Repeat steps outlined above for the other wheel installation .
Item Description
1 Tank Assembly
2 Wheel Assembly
3 Flat Washer
4 Castle Nut
5 Cotter Pin
6 Dust Cap
18
1
Quantity
2
2
2
2
2
2
2
1 3 1 4 1 5 1 6