Troubleshooting; Warranty Info - Enerwatt MOTO M3 Guide D'utilisation

TROUBLESHOOTING

PROBLEM
1. No warnings appear
on the display.
2. The power warning
When I turn my
light is on.
vehicle on,
nothing happens.
3. The power warning light
and the break light are on.
The throttle does
not work or
switch on, the 1. The throttle does not return
vehicle moves to the stop position.
without
acceleration.
The range is low. Charger light is off.
Battery doesn't hold
Charger.
the charge.
The breaks are
1. Break levers go too deep.
not working
2. No breaking power.
properly.

WARRANTY INFO

WARRANTY
The manufacturer warrants to the original retail purchaser (yourself ) that the Moto M3
for which this warranty has been issued is free from the following material and workmanship defects:
12 months warranty:
• Frame
• Electric Motor
• Controller and electric circuits
• SLA Battery and charger
This warranty cannot be transferred to subsequent purchasers.
The manufacturer's sole obligation under this warranty is to repair or replace the product (the manufacturer choses which one).
The manufacturer must be notified in writing of any claim under this warranty within 15 days of noticing any issues.
You must immediately report any abnormal behaviour to the Moto M3 retailer.
CONDITION
1. Check if the main breaker under the seat
2. Check the power connection and
3. Check battery and motor connection.
4. Check if the break levers have been
5. Battery voltage is below 42 volts.
1. Check the grip for damage.
2. Check the throttle spring.
3. Check if the throttle handle is loose.
1. Bad connection between the charger
2. Charger doesn't charge.
1. Connections between the batteries
2. Faulty battery cell.
1. Needs adjustment.
2. Break pads are dirty or need replacing.
CHECK
is in the "ON" position.
battery level.
returned to their original position.
and the battery.
are faulty.
EWB-MOTOM3-BK
USER'S MANUAL
SOLUTION
1. Flip the breaker lever to "ON" .
2. Fasten connections.
3. Clean and fasten the battery
terminal connectors.
4. Fasten the motor connections using
the controller under the seat.
5. Loosen the break. If there is any
corrosion, replace it.
Contact the supplier.
6. Charge or replace the battery.
Contact the supplier.
1.Use a flat head screwdriver to adjust
the gap between the rubber handle
and the cover.
2. Readjust the throttle spring position.
Contact the supplier.
3. Check the throttle connections.
Contact the supplier.
1. Check the charger plug position.
2. Replace the charger.
1. Check all connections between
the batteries.
2. Replace the faulty battery cell.
1. Adjust the break cable see instructions.
2. Clean break pads using sand paper
or replace.
24