filtreau COMBI NEXT Manuel page 6

GB FILTREAU COMBI NEXT
OPERATION
The Filtreau Combi NEXT is a low-maintenance filter system that ensures healthy and clear water without the user
having to carry out daily maintenance.
The fully automatic drum filter, combined with the moving bed/bio chamber, makes the filter suitable for (koi) ponds
of up to 45,000 litres!
The system is equipped as standard with 3 inlets (110 mm) and 2 outlets (110 mm).
This enables a water flow of no less than 30 m3/h to be achieved!
ATTENTION! Please read the entire manual before using/installing the system.
If in doubt, always consult a qualified installer.
SAFETY AND INSTALLATION REQUIREMENTS
• See the Technical Specifications for the required mains voltage and type of current.
• The appliance may only be connected to an electrical installation that complies with legal standards. A residual
current circuit breaker (30 mA) and an earthed socket are required. If in doubt, always consult a qualified installer.
• The filter, control box and condenser (of the rinse pump) should be placed in a dry, sheltered place. Not in direct
sunlight.
• Always keep the plug free from moisture. Prevent water from running into the socket along the power cord (see
Figure 1 for how to loop the power cord).
• The appliance is suitable for fresh water.
• The appliance is suitable for water temperatures from 4 – 40 degrees Celsius. If temperatures exceed these
limits, the appliance must be completely disconnected from the water circuit.
• Check the entire appliance, power cord and plug for damage before use. In the event of damage, do not use the
appliance. Have the damage assessed by the dealer.
• The appliance may only be switched on if there is sufficient water flow.
• When opening the cover or carrying out maintenance, the power supply to the appliance/control box must be
switched off at all times.
INSTALLATION FILTREAU COMBI NEXT; SEE FIGURES 1 TO 5
1. Determine the exact location of the filter and place it on a stable, flat base.
2. Place the filter behind or in front of the pond pump, in a designated position (behind pond pump=pump-fed / in
front of pond pump=gravity-fed) and remove the cover (A) from the housing.
Please note that the maximum water level of the pond is never higher than the maximum water level in the
filter. Max. water level = 1 cm below the waste outlet/gutter.
3. A) *Take the rinse pump (B) out of the package, connect the outlet to the PVC coupling and tighten everything
well. (This step is only for filters that are delivered with a built-in rinse pump).
B) Connect the outlet of the external rinse pump to the inlet of the filter using high-quality pressure PVC and/or
flexible sleeve(s). (This step is only for filters that are delivered without a built-in rinse pump)
4. Connect the air pump (min. 40 l/hour) to the sleeve (C).
5. Connect the outlet (D) of the filter to the return pipe of your pond.
6. Gravity-fed set-up; Fill the pond until the maximum water level is reached. Max. water level = 1 cm below the
waste outlet/gutter.
7. Replace the cover (A) on the housing.
8. Now insert the plugs of the appliances into the correct sockets on the control box (F) (see indications on the
control box itself).
9. Connect the cable from the float to the cable of the control box (F) (DMX connection).
10. Now insert the plug (G) of the control box (F) into the socket provided and switch it on by turning the switch (H).
6